Re: Network card found but not configured with Etch / 2.6 kernel
On 14.06.07 08:20, Ken McCord wrote:
> Have an IBM NetVista 6341-64U system (1.0 GHz Celeron, 512 MB RAM,
> onboard Intel Ethernet adapter) that when Etch boots on it, will detect
> an installed network card, but when networking is configured to start,
> will not start it. Here's the output of some commands from a fresh boot:
>
> dmesg | grep eth0
> e100: eth0: e100_probe: addr 0xfebff000, irq 5, MAC addr 00:02:55:25:65:FB
>
> ifconfig eth0 up
> eth0: ERROR while getting interface flags: No such device
didn't you turn it off in BIOS setup?
--
Matus UHLAR - fantomas, uhlar@fantomas.sk ; http://www.fantomas.sk/
Warning: I wish NOT to receive e-mail advertising to this address.
Varovanie: na tuto adresu chcem NEDOSTAVAT akukolvek reklamnu postu.
There's a long-standing bug relating to the x86 architecture that
allows you to install Windows. -- Matthew D. Fuller
Reply to: