Re: How to read from an built in card reader ?

["Jabka Atu" <mashrom.head@gmail.com>]

im using Debian (Mentally?)Unstable

no new sd or mmc in dev .. 
also in dmesg only said : 
ACPI: PCI interrupt for device 0000:06:04.2 disabled
sdhci: Secure Digital Host Controller Interface driver, 0.12
sdhci: Copyright(c) Pierre Ossman
sdhci: SDHCI controller found at 0000:06:04.2 [1524:0550] (rev 1)
PCI: Enabling device 0000:06:04.2 (0000 -> 0002)
ACPI: PCI Interrupt 0000:06:04.2[B] -> GSI 23 (level, low) -> IRQ 233
mmc0: SDHCI at 0xc0202800 irq 233 DMA

im using sdhci and mmc-block

On 1/13/07, Osamu Aoki <osamu@debian.org > wrote:

On Sat, Jan 13, 2007 at 04:47:55PM +0200, Jabka atu wrote:
> Hello  && good evening..
>
> i have a built in card reader but i don't know how to enable and how to
> mound cards,
>
> here is my lspci
> 06:04.0 CardBus bridge: ENE Technology Inc CB-712/4 Cardbus Controller
> (rev 10)
> 06:04.1 FLASH memory: ENE Technology Inc ENE PCI Memory Stick Card
> Reader Controller (rev 01)
> 06:04.2 Generic system peripheral [0805]: ENE Technology Inc ENE PCI
> Secure Digital Card Reader Controller (rev 01)
> 06:04.3 FLASH memory: ENE Technology Inc FLASH memory: ENE Technology
> Inc: (rev 01)
> 06:04.4 FLASH memory: ENE Technology Inc Unknown device 0551 (rev 01)

These memory stick, flash, ... are read as SCSI disk.  Auto activated by
udev.