[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Cable Modem / Internet / Built-in 10-100 Ethernet / Slows & Then Stalls...



This is odd, (VERY)
when surfing its okay, however, when downloading like new iso image files,
or ftping... the ethernet connection seems to come to a crawl, then stops 
(cold) (please note: in Window XP (oops) there was never a problem in 
downloading. <little grin>

Here is my snap of ifconfig -a
-----------------------------
$ ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:03:25:28:93:B3
          inet addr:24.92.160.221  Bcast:255.255.255.255  Mask:255.255.248.0
          UP BROADCAST RUNNING MULTICAST  MTU:576  Metric:1
          RX packets:159889 errors:0 dropped:0 overruns:0 frame:33
          TX packets:46346 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:33793861 (32.2 MiB)  TX bytes:3929165 (3.7 MiB)
          Interrupt:50

eth1      Link encap:Ethernet  HWaddr 00:14:A5:41:E4:99
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:11

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

sit0      Link encap:IPv6-in-IPv4
          NOARP  MTU:1480  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
---------------------------------------------------------
Here is a dump of lspci -vv ( just the ethernet eth0 )
Ethernet controller: Marvell Technology Group Ltd. 88E8036 PCI-E Fast Ethernet 
Controller (rev 10)
        Subsystem: Gateway 2000 Unknown device 0506
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0, Cache Line Size: 32 bytes
        Interrupt: pin A routed to IRQ 58
        Region 0: Memory at c0100000 (64-bit, non-prefetchable) [size=16K]
        Region 2: I/O ports at a000 [size=256]
        Capabilities: [48] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=1 PME-
        Capabilities: [50] Vital Product Data
        Capabilities: [5c] Message Signalled Interrupts: 64bit+ Queue=0/1 
Enable+
                Address: 00000000fee00000  Data: 403a
        Capabilities: [e0] Express Legacy Endpoint IRQ 0
                Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag-
                Device: Latency L0s unlimited, L1 unlimited
                Device: AtnBtn- AtnInd- PwrInd-
                Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
                Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
                Device: MaxPayload 128 bytes, MaxReadReq 512 bytes
                Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 3
                Link: Latency L0s <256ns, L1 unlimited
                Link: ASPM Disabled RCB 128 bytes CommClk- ExtSynch-
                Link: Speed 2.5Gb/s, Width x1
        Capabilities: [100] Advanced Error Reporting
----------------------------------------------------

Here is the dump of lspci -vvn (eth0)
02:00.0 0200: 11ab:4351 (rev 10)
        Subsystem: 107b:0506
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0, Cache Line Size: 32 bytes
        Interrupt: pin A routed to IRQ 58
        Region 0: Memory at c0100000 (64-bit, non-prefetchable) [size=16K]
        Region 2: I/O ports at a000 [size=256]
        Capabilities: [48] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=1 PME-
        Capabilities: [50] Vital Product Data
        Capabilities: [5c] Message Signalled Interrupts: 64bit+ Queue=0/1 
Enable+
                Address: 00000000fee00000  Data: 403a
        Capabilities: [e0] Express Legacy Endpoint IRQ 0
                Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag-
                Device: Latency L0s unlimited, L1 unlimited
                Device: AtnBtn- AtnInd- PwrInd-
                Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
                Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
                Device: MaxPayload 128 bytes, MaxReadReq 512 bytes
                Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 3
                Link: Latency L0s <256ns, L1 unlimited
                Link: ASPM Disabled RCB 128 bytes CommClk- ExtSynch-
                Link: Speed 2.5Gb/s, Width x1
        Capabilities: [100] Advanced Error Reporting
-------------------------------------------------------------

Again, this is very frustrating having to reboot, to fix this problem
when it stalls... 

Thanks - in Advance.
Rich



Reply to: