dhcpcd loses IP address after update [debian unstable]
Hi,
I am running debian unstable and just upgraded the system.
I use dhcpcd (2.0.3) as DHCP client, which worked fine until the update.
So, now I dhcpcd gets everything from the DHCP server but seems to
forget it almost immediately (it then falls back to some IPv4 link-local
address).
Here is how it goes:
- ifup eth0
... dhcpcd.exe confirms IP Addr 192.150.186.186
- ifconfig (immediately after)
eth0 Link encap:Ethernet HWaddr 00:06:5B:89:58:F8
inet addr:192.150.186.186 Bcast:192.150.186.255
Mask:255.255.255.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3194 errors:0 dropped:0 overruns:1 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:316287 (308.8 KiB) TX bytes:3498 (3.4 KiB)
Interrupt:11 Base address:0xa000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:276 (276.0 b) TX bytes:276 (276.0 b)
- ifconfig (again some seconds later)
eth0 Link encap:Ethernet HWaddr 00:06:5B:89:58:F8
inet addr:169.254.204.255 Bcast:169.254.255.255
Mask:255.255.0.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3343 errors:0 dropped:0 overruns:1 frame:0
TX packets:23 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:331386 (323.6 KiB) TX bytes:3558 (3.4 KiB)
Interrupt:11 Base address:0xa000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:276 (276.0 b) TX bytes:276 (276.0 b)
So it seems that the IP Addr gets lost somewhere.
I am not aware of any other network configuration software that is running.
As an exercise I even deleted everything from /etc/rc2.d in order to
eliminate interferences with any other deamons.
Nothing changed, though.
my /etc/network/interfaces looks like this:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet dhcp
Do you have any ideas about this strange behavior?
Any help would be greatly appreciated.
Many Thanks,
Jan
Reply to: