Polling of via-rhine failed
Hi,
I recently reinstalled a P2-350 which has been running a pre-release
version of sarge, with a 2.6.6. kernel.
Installation went OK with a 2.4 kernel, but when switching to the
standard 2.6.8, polling of the network card fails with the following error:
via-rhine.c:v1.10-LK1.1.20-2.6 May-23-2004 Written by Donald Becker
ACPI: PCI interrupt 0000:00:0b.0[A] -> GSI 12 (level, low) -> IRQ 12
via-rhine: probe of 0000:00:0b.0 failed with error -945243616
Attempting with acpi=off lead to similar results:
via-rhine.c:v1.10-LK1.1.20-2.6 May-23-2004 Written by Donald Becker
PCI: Found IRQ 12 for device 0000:00:0b.0
via-rhine: probe of 0000:00:0b.0 failed with error -951156192
For reference, this is what 2.4 reports:
via-rhine.c:v1.10-LK1.1.19 July-12-2003 Written by Donald Becker
http://www.scyld.com/network/via-rhine.html
PCI: Found IRQ 12 for device 00:0b.0
eth0: VIA VT86C100A Rhine at 0x6800, 00:60:67:44:a9:fb, IRQ 12.
eth0: MII PHY found at address 1, status 0x782d advertising 05e1 Link 41e1.
The full dmesg logs are available at http://web.ncf.ca/jmranger/via/
Does this ring a bell to anyone ?
Thanks,
Jean-Marc Ranger
Reply to: