Re: Wireless Card on linux
I have tried compiling ndiswrapper again and also compiled a new
2.4.32 kernel but get an error after installing ndiswrapper. It
detects the card but no lights come up when using iwconfig to make it
up. I'm attaching a text file with the commands I use and the
errors/results I get
I did not have the WIndows driver CD for the Netgear PC card so I
downloaded the drivers from the net.
Regards,
Deboo
On 2/10/06, Deboo ^ <knowledgeful@gmail.com> wrote:
> Hello,
>
> I have a Compaq Armada with a Netgear wireless PC card (the one
> which is linux supported), could someone detail the steps needed to
> make it work fully?
>
> And how to make both the wired lan and wireless lan work together. I
> guess it has to do something with routing but not very sure. Last time
> I made a script to make one interface down and other up, but that's a
> pain for others to do who like to use the gui.
>
> I have the ndiswrapper already installed and detecting the card
> hardware. What oither steps are needed, what commands etc and how to
> configure?
>
> Regards,
> Deboo
>
> --
> Please don't Cc: me, I'm subscribed to the list.
>
--
Please don't Cc: me, I'm subscribed to the list.
[root@linux root]# lspci | grep 3890
03:00.0 Network controller: Harris Semiconductor: Unknown device 3890 (rev 01)
[root@linux root]# dmesg|grep eth1
eth1: resetting device...
eth1: uploading firmware...
eth1: could not upload firmware ('isl3890')
eth1: islpci_reset: failure
eth1: resetting device...
eth1: uploading firmware...
eth1: could not upload firmware ('isl3890')
eth1: islpci_reset: failure
[root@linux root]# iwconfig eth1
eth1 NOT READY! ESSID:"default"
Mode:Managed Channel:0 Access Point: 00:00:00:00:00:00
Tx-Power=31 dBm Sensitivity=0/0
Retry min limit:0 RTS thr=0 B Fragment thr=0 B
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@linux root]# iwlist eth1 scanning
eth1 No scan results
[root@linux root]# ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:30:B4:00:00:00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11
Reply to: