Re: libapache2-mod-jk2 configuration
I'd stay away from jk2 is deprecated in favour of maintaining the
original mod_jk. The configuration for jk2 meant more hoop-jumping
than with jk and thus is fell out of favour..
Unfortunatly the apache2 modules for the debian distribution only has
a compiled jk2. Assuming you want to use the debain aptitude stuff,
I'd install the apache1 stuff rather than 2 until someone creates
mod_jk for apache 2 on debian.
This link takes you through the basics, and the configuration
differences between apache 1 and 2 or minimal..
http://raibledesigns.com/tomcat/
Mark
On 6/23/05, Alan Chandler <alan@chandlerfamily.org.uk> wrote:
> I am trying to add tomcat4 into my existing apache2 system so that I can
> experiment with java (in the form of servlets and jsp).
>
> Although in reality I only have a single computer, for learning purposes I
> want to similate the situation where I have potentially split web and
> application servers.
>
> So this server has two ethernet cards - one facing the outside world with an
> address assigned by my isp using dhcp. www.chandlerfamily.org.uk points at
> this address.
>
> On the other side, my lan side, I have allocated myself a range of io
> addresses using eth1 (192.168.0.20) eth1:0 (192.168.0.30) eth1:1
> (192,168.0.31) as the devices (and their ip addresses) created via iface
> stanzas in /etc/networking/interfaces.
>
> Bind is used to provide different names to the different lan based ip
> addresses
>
> An iptables firewall protects the addresses and does NAT.
>
> Using Apache2, I then use ip based virtual hosts, so the external address has
> one web site for http and two of the internal addresses support two other
> http web sites. https is allocated a further host on the external address to
> replicate one of the internal sites and providing secure access to webmail.
>
> I would like to set up tomcat so that it acts as though it were running on the
> single ip address 192.168.0.31 (although appropriate requests to my external
> web site - are routed through to it via apache).
>
> Obviously therefore I need to connect apache2 to tomcat4 and therefore
> installed libapache2-mod-jk2.
>
> However, there doesn't seem to be any clear documentation to tell me how to
> achieve a configuration of this connector to tell me what to do. There are
> examples of configuration and a howto, but all of them assume a particular
> configuration and so don't explain what all the keywords mean.
>
> If you look on the jakata.apache.org web site it says that mod_jk2 is
> depreciated and that mod_jk is the only one supported. However if I look at
> debian packages mod_jk seems to only be for apache1 and for apache2 I only
> have choice of mod_jk2.
>
> So some questions
>
> -why is there no libapache2-mod-jk package (even in unstable - although my
> server is running sarge)?
>
> -where can I find a full explanation of the workers2.properties configuration
> parameters
>
> -where can I find a full explanation of the mod_jk2 directives that go in my
> apache2 configuration
>
> -can someone on these mailing lists help me unravel the example configuration
> files and configure them to meet my requirements listed above
>
>
>
>
>
>
> --
> Alan Chandler
> http://www.chandlerfamily.org.uk
>
>
> --
> To UNSUBSCRIBE, email to debian-java-REQUEST@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
>
>
Reply to: