Re: Network Everywhere NX100U-WM NIC
Kent West <westk@acu.edu> wrote:
>
> Marc Shapiro wrote:
>
> >Kent West <westk@acu.edu> wrote:
> >
> >
> >>Can you "ping localhost"?
Yes. From either box.
> >>Can you ping your gateway, by address? by name?
No. From neither box.
When I attempt a ping from either box to the other,
both sets of lights on the switch blink, suggesting
that data is going through the switch, both NICs and
both cables. The lights on the switch correctly show
100Mb/sec full-duplex connections from both machines.
I have already changed the NIC on the gateway machine
in an attempt to solve this. The desktop machine has
a built in NIC and is only a few months old.
Everything worked fine until about a week ago.
> What does your "/etc/network/interfaces" look like?
> What's the result of "ifconfig"?
On the desktop box (xander -- 192.168.0.3):
/etc/network/interfaces:
# /etc/network/interfaces -- configuration file for
ifup(8), ifdown(8)
# The loopback interface
auto lo
iface lo inet loopback
# The first network card - this entry was created
during the Debian installation
# (network, broadcast and gateway are optional)
auto eth0
iface eth0 inet static
address 192.168.0.3
netmask 255.255.255.0
network 192.168.0.0
broadcast 192.168.0.255
output of ifconfig:
eth0 Link encap:Ethernet HWaddr
00:11:5B:1B:8F:1F
inet addr:192.168.0.3 Bcast:192.168.0.255
Mask:255.255.255.0
inet6 addr: fe80::211:5bff:fe1b:8f1f/64
Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500
Metric:1
RX packets:0 errors:0 dropped:0 overruns:0
frame:0
TX packets:223 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:9534 (9.3 KiB)
Interrupt:19 Base address:0xe400
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:193 errors:0 dropped:0 overruns:0
frame:0
TX packets:193 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:0
RX bytes:72672 (70.9 KiB) TX bytes:72672
(70.9 KiB)
/etc/hosts:
127.0.0.1 local.net xander localhost
loopback
192.168.0.1 mareschal
192.168.0.2 alexander
192.168.0.3 xander
# The following lines are desirable for IPv6 capable
hosts
# (added automatically by netbase upgrade)
::1 ip6-localhost ip6-loopback
fe00::0 ip6-localnet
ff00::0 ip6-mcastprefix
ff02::1 ip6-allnodes
ff02::2 ip6-allrouters
ff02::3 ip6-allhosts
/etc/networks:
localnet 192.168.0.0
output of mii-tool:
eth0: negotiated 100baseTx-FD, link ok
On the gateway box (mareschal -- 192.168.0.1):
/etc/network/interfaces:
# Used by ifup(8) and ifdown(8). See the interfaces(5)
manpage or
# /usr/share/doc/netbase/examples for more
information.
#
iface lo inet loopback
iface ppp0 inet ppp
iface eth0 inet static
address 192.168.0.1
netmask 225.225.225.0
broadcast 192.168.0.225
network 192.168.0.0
up route add default ppp0
down route del ppp0
output of ifconfig:
eth0 Link encap:Ethernet HWaddr
00:12:17:54:0D:EF
inet addr:192.168.0.1 Bcast:192.168.0.255
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500
Metric:1
RX packets:0 errors:0 dropped:0 overruns:0
frame:0
TX packets:48 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:2016 (1.9 KiB)
Interrupt:11 Base address:0x2400
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:67 errors:0 dropped:0 overruns:0
frame:0
TX packets:67 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:0
RX bytes:7028 (6.8 KiB) TX bytes:7028 (6.8
KiB)
/etc/hosts:
127.0.0.1 local.net mareschal
localhost loopback
192.168.0.1 mareschal
192.168.0.2 alexander
192.168.0.3 xander
# The following lines are desirable for IPv6 capable
hosts
# (added automatically by netbase upgrade)
::1 ip6-localhost ip6-loopback
fe00::0 ip6-localnet
ff00::0 ip6-mcastprefix
ff02::1 ip6-allnodes
ff02::2 ip6-allrouters
ff02::3 ip6-allhosts
/etc/networks:
localnet 127.0.0.0
output of mii-tool:
eth0: negotiated 100baseTx-FD flow-control, link ok
Reply to: