Re: minicom: how to send control -c to remote machin

[Mitchell Laks <mlaks@verizon.net>]

Dear Miquel,
Thank you so much. You are right. The intr key is undefined remotely! see 
below. I trid to set my TERM to vt100, but that doesnt seem to affect it. 
What can I do next?

Thanks for this info! 
Mitchell

[mlaks@remote mlaks]$stty -a
speed 57600 baud; rows 0; columns 0; line = 0;
intr = <undef>; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;
eol2 = <undef>; start = ^Q; stop = ^S; susp = ^Z; rprnt = ^R; werase = ^W;
lnext = ^V; flush = ^O; min = 1; time = 0;
-parenb -parodd cs8 hupcl -cstopb cread -clocal crtscts
-ignbrk brkint ignpar -parmrk -inpck -istrip -inlcr -igncr icrnl -ixon -ixoff
-iuclc -ixany -imaxbel
opost -olcuc -ocrnl onlcr -onocr -onlret -ofill -ofdel nl0 cr0 tab3 bs0 vt0 
ff0
isig icanon -iexten echo echoe echok -echonl -noflsh -xcase -tostop -echoprt
-echoctl -echoke
[mlaks@remote mlaks]$ export TERM=vt102
[mlaks@remote mlaks]$ stty -a
speed 57600 baud; rows 0; columns 0; line = 0;
intr = <undef>; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;
eol2 = <undef>; start = ^Q; stop = ^S; susp = ^Z; rprnt = ^R; werase = ^W;
lnext = ^V; flush = ^O; min = 1; time = 0;
-parenb -parodd cs8 hupcl -cstopb cread -clocal crtscts
-ignbrk brkint ignpar -parmrk -inpck -istrip -inlcr -igncr icrnl -ixon -ixoff
-iuclc -ixany -imaxbel
opost -olcuc -ocrnl onlcr -onocr -onlret -ofill -ofdel nl0 cr0 tab3 bs0 vt0 
ff0
isig icanon -iexten echo echoe echok -echonl -noflsh -xcase -tostop -echoprt
-echoctl -echoke