install fails
When trying to install "sarge" in either expert or expert26 mode I
get the following at the prompt:
loading /install/vmlinuz
loading /install/initrd.gz
Ready.
and then the computer locks up.
It's a Gateway ALR8300, with one SCSI drive off an on-board AIC
7890 interface.
If I install the woody dist using "vanilla" I can install, but
when trying to upgrade to kernel 2.4.19 it boots with the agpgart
module and freezes. I compiled a new kernel with AGP turned off,
but it still tries to run agpgart and freezes on boot.
I am stymied.
Reply to: