Sarge install problems with Adaptec 7902 controller

[Raj Kiran Grandhi <rajkirangrandhi@gmail.com>]

Hi,

I am trying to install sarge on a HP Workstation with a Seagate SCSI
disk on an Adaptec 7902 Ultra 320 SCSI adapter. However, the installer
fails to detect the hard disk at all. There was no such problem when
installing Redhat 9. Redhat loads the module aic79xx.o before the
install program begins. During sarge install, lsmod shows that the
module aic79xx.o is loaded, but still the hard disk is not detected. I
am stuck as to what is to be done. Any pointers would be greatly
helpful.

Thanks and regards,

Raj Kiran