RE: move from old HD to new hd...
Couldn't possibly do it because I needed the drivers that I compiled
especially for my non working scsi card..
Now I have to figure out how to package my kernel into an installer.
-Paul
---------------------------
Paul Matuszewski
Systems Administration
In Office Networks
http://www.inofficenetworks.com
V:(516) 816-4871
V:(305) 799-4871
F:(305) 441-2804
-----Original Message-----
From: Ron Johnson [mailto:ron.l.johnson@cox.net]
Sent: Sunday, June 01, 2003 3:45 PM
To: Debian-User
Subject: Re: move from old HD to new hd...
On Sun, 2003-06-01 at 13:48, Kevin McKinley wrote:
> On Sun, 01 Jun 2003 13:50:05 -0400
> Paul Matuszewski <sase@five-elements.com> wrote:
>
> > I have a bare new ssytem (but with the correct modules installed for my
> > network interface cards and scsi controller...
> >
> > How can i move all the files from the ide to the new scsi disk.. and get
> > it to boot up on it.
> >
> > I mean.. obviously.. the best thing to do is to partition the scsi disk
in
> > the same manor as the ide first..
> >
> > but then how to change/copy the files.. and make it bootable?
>
> I did this by first partitioning the new hard drive. The partitions are
not
> required to be the same size as the old ones, and they are not required to
> use the same type of filesystem.
>
> Then I booted with a rescue CD and mounted the partition I wanted to copy
as
> /mnt/old and the destination partition as /mnt/new, followed by "cp -a
> /mnt/old/* /mnt/new". That took about a cup of coffee (I sipped slowly.) I
> repeated the mount/copy process for each partition on the old hard drive.
>
> Then I dd'd the boot loader in the MBR with "dd if=/dev/hda bs=448 count=1
> of=/dev/hdb" assuming /dev/hda is the old drive and /dev/hdb is the new.
> (This will not disturb the partition table in the MBR.)
>
> Since Windows was one of the operating systems, I also dd'd the boot
sector
> of the Windows partition, with the same bs=448.
>
> Then I swapped the drives and rebooted. It worked.
Of course, if you have broadband, you could always re-install Debian,
then restore /home and config files...
That has the side benefit of eliminating cruft.
--
+-----------------------------------------------------------+
| Ron Johnson, Jr. Home: ron.l.johnson@cox.net |
| Jefferson, LA USA http://members.cox.net/ron.l.johnson |
| |
| Regarding war zones: "There's nothing sacrosanct about a |
| hotel with a bunch of journalists in it." |
| Marine Lt. Gen. Bernard E. Trainor (Retired) |
+-----------------------------------------------------------+
--
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact
listmaster@lists.debian.org
Reply to: