Re: USB floppy problems (more details)
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Es Dilluns 29 Setembre 2003 01:44, en Oleg Trott va escriure:
> I have a USB floppy connected and sg.o, sd_mod.o and usb-storage.o loaded.
> The device does not show up in /proc/scsi/scsi however, and
> mount -t auto /dev/sda /floppy
> fails ("not a valid block device") The drive works under Windows and BIOS
> though. Any ideas? I'm using linux-2.4.22 and DevFS
I've got mine working with usb-storage and sd_mod modules loaded. dmesg
command is going to tell you about it:
- -----
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: MITSUMI Model: USB FDD Rev: 1039
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
usb-uhci.c: interrupt, status 3, frame# 197
SCSI device sda: 2880 512-byte hdwr sectors (1 MB)
sda: Write Protect is off
sda: sda1 sda2 sda3 sda4
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
- -----
Good luck ;)
- --
Joan Tur. Eivissa-Spain
Jabber, Yahoo & AIM: quini2k
www.ClubIbosim.org
Linux: usuari registrat 190.783
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)
iD8DBQE/eFzdok8j9RhtetwRAkSTAKCDIt/1y9VphX+YR8N9lifmdS7jswCgoaCs
zZVb+LOYWPRjWD5ZMruqmGQ=
=hG6A
-----END PGP SIGNATURE-----
Reply to: