Re: how to make hda become hdb?
"Pigeon" == jah pigeon <Pigeon> writes:
>> According to IDE specs, master is supposed to go on the end of
>> the cable.
Pigeon> I think that for reasons of termination (such as it is for
Pigeon> IDE), if you only have one drive, it should go on the end
Pigeon> of the cable. If you have two, I don't think it matters
Pigeon> which is where, especially since the difference in status
Pigeon> implied by "master" and "slave" is an artefact of the
Pigeon> terminology with no counterpart in the functioning of the
Pigeon> interface. This is empirical, of course. But on a cable
Pigeon> with two drives, I've never found it to matter which goes
Pigeon> where.
Unless you set your drives to "cable select" and use an IDE cable that
automatically chooses master and slave for you. Apparently these
exist, though I've never used one (and would avoid it).
Cheers!
Shyamal
Reply to: