Re: Compiling a new kernel
On Mon, 2002-11-04 at 07:12, Emanuele Boieri wrote:
> Hi everybody I hope that somenone can help me. I just followed
> precisely the instruction for compiling/installing a new kernel
>(2.4.19). The previeous version was 2.2.
> 1.. tar xvjf "the kernel source"
> 2.. make menuconfig
> 3.. make dep
> 4.. make bzImage
> 5.. make modules
> 6.. make modules_install
> then I copied the new image in the boot location of the old
> one /boot/bzImage.(I saved the old one). So I edit the lilo.conf and I
> specified where to load the new image. After rebooting (everything
> seemed to go fine) I launched the "kernelversion" command but the
> answer was 2.2!!! What happened??
> I want to precise that I've been using for one month and that
> I'm a very new user!
>
> Thanks in advance to everyone with a good solution
> Emanuele
Did you run lilo after changing lilo.conf so the boot sector was
updated?
G
--
Configure your Email to send TEXT ONLY -- See the following page:
http://expita.com/nomime.html
gvl2 (Gerald)
AirBall the Rolling Basket Case (1969 Standard Beetle)
LifeSaver (1974 Bay Window Bus)
http://www.phorce1.com
Reply to: