configuring sound card

[Mark Copper <m.copper@wayne.edu>]

Hi,

I'm doing a new install of current stable on an i386 with a Turtle beach
Santa Cruz sound card.  I use bf24 installation program because,
apparently I need the cs46xx driver in kernel version 2.4 to run this
card.

Installation seems to go fine, the cs46xx driver installs successfully,
the machine reboots and cdtool works.  Unfortunately the signal is only
for headphones; it is unchanged even after the machine has been halted.

Then, after the machine has been rebooted, the driver doesn't load
anymore.  I get this from dmesg:

PCI: Found IRQ 5 for device 00:09.0
PCI: Sharing IRQ 5 with 00:04.2
Crystal 4280/46xx + AC97 Audio, version 1.28.32, 10:28:40 Apr 14 2002
cs46xx: Card found at 0xde800000 and 0xde000000, IRQ 5
cs46xx: Voyetra (5053:3357) at 0xde800000/0xde000000, IRQ 5
cs46xx: AC'97 write problem, reg = 0x0, val = 0x0
cs46xx: AC'97 read problem (ACCTL_DCV), reg = 0x0 returning 0xffff
ac97_codec: Primary ac97 codec not present
cs46xx: cs_ac97_init() failure
cs46xx: cs46xx_probe()- cs_hardware_init() failed, retried 5 times.
cs46xx: probe()- no device allocated
cs46xx: Unable to detect valid cs46xx device

Is the shared IRQ a problem?  Should I recompile the kernel with cs46xx as
a module?

I would be very appreciative of any help from the list.

Mark