lilo and OpenBSD

[Kang-Ling Weng <jkdebian@gmx.net>]

Hello debian-user,

  I have got 2 harddrives
  hda with Debian
  hdb with OpenBSD

  now I am trying to config lilo
  so that I am to boot into OpenBSD
  but when adding:

  other=/dev/hdb1
        label=OpenBSD
        read-only
        alias=3

  to lilo.conf
  and run: lilo
  the output looks like that:

  Skipping /vmlinuz.old
  Device 0x0340: Invalid partition table, 1st entry
  3D address:     0/0/0 (-1)
  Linear address: 1/0/0 (0)

  it seems that lilo can't recognize hdb

  I tried: cfdisk hdb

  FATAL ERROR: Cannot open disk drive
  Press any key to exit cfdisk

  when I pull off the ide cable of my hda my pc boot
  into OpenBSD so OpenBSD was installed probably

  what should I modify in lilo.conf so I can boot into OpenBSD??

  
-- 
Best regards,
 Kang-Ling                          mailto:jkdebian@gmx.net


-- 
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org 
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org