Re: S3 TRIO 32 and XFree86?
Charlie Grosvenor wrote:
>
> I have just installed xserver-s3 and used Debian conf to configure it.
> When I try and run it I get the following:
> (**) S3: Mode "800x600": mode clock = 40.000
> (--) S3: Too little memory for mode "800x600"
> (--) S3: NB. 1 scan line is required for the hardware cursor
> (--) S3: Removing mode "800x600" from list of valid modes.
> (**) S3: Mode "640x480": mode clock = 25.200
> (--) S3: Too little memory for mode "640x480"
> (--) S3: NB. 1 scan line is required for the hardware cursor
>
> Fatal server error:
> No valid modes found.
Hi Charlie,
seems like you dont have enough videomemory for 640x480,
(which is 307 k pixels),
so if 1 Mbyte is not enough it probably means that
you are trying to use 4 bytes/pixel.
in the config file this is called depth,
and depth 32 is 4 bytes/pixel
with my xserver (ati) depth 24 is also 4 bytes/pixel,
because it cant do 3 bytes/pixel.
try setting depth of 640x480 to 16.
(should also work for 800x600)
your config file would then contain something like :
Section "Screen"
Driver "Accel"
Device "Your Card"
Monitor "Your Monitor"
DefaultColorDepth 16
SubSection "Display"
Depth 8
Modes "800x600" "640x480"
EndSubSection
SubSection "Display"
Depth 16
Modes "800x600" "640x480"
EndSubSection
EndSection
hope this helps
have fun !
Siward
--
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: