Re: XF86Config-4 and Voodoo3 2000 agp botchup
Could you post your XF86Config-4.
Glen Snyder wrote:
> I upgraded a machine at work to Woody. No problem at the start, gdm runs
> fine, but both KDE and Gnome (Debian) crash on startup. I also recompiled
> the kernel to 2.4.18 and installed DRI and agppart, but not improvement.
> It looks like XFree86 probes the card ok:
>
> ---cut----
> (II) Bus -1 non-prefetchable memory range:
> (II) Bus -1 prefetchable memory range:
> (--) PCI:*(1:0:0) 3dfx Interactive Voodoo3 rev 1, Mem @ 0xde000000/25,
> 0xe2000000/25, I/O @ 0xd800/8, BIOS @ 0xe1ff0000/16
> (II) Addressable bus resource ranges are
> [0] -1 0 0x00000000 - 0xffffffff (0x0) MX[B]
> [1] -1 0 0x00000000 - 0x0000ffff (0x10000) IX[B]
>
>
> but then it doesn't work in the end.
> ----cut-----
>
>
> (II) TDFX: Driver for 3dfx Banshee/Voodoo3 chipsets: 3dfx Banshee,
> 3dfx Voodoo3, 3dfx Voodoo5
> (II) Primary Device is: PCI 01:00:0
> (WW) TDFX: Chipset "Voodoo3" in Device section "Card0" isn't valid for
> this driver
> (EE) No devices detected.
>
>
>
> Should I call it something else from Card0 when I use xf86cfg????Does it
> matter that it is agp, and is on bus 1, rather than pci on bus 0???? Or is
> this some other problem? The card is listed in /proc/pci
>
> I don't really need 3d graphics at work,anyway if that's a problem. I do
> need to get it back to running gnome, though. If anyone has a
> suggestion, I thank you in advance.
>
> -Glen
--
Simon Hepburn.
Reply to: