On Wed, Aug 29, 2001 at 10:03:57PM -0400, JakeCatfox@aol.com wrote:
> I have a Linksys Etherfast 10/100, I think it's revision 3, though. All you
> should need to do is enable the driver in the kernel, compile, then, if you
> compile it as a module (I compile it statically), you'll need to make modules
> and make modules-install, and modprobe/insmod the module. Turn off PnP OS in
> your BIOS if it's on.
That last point is a good one. I couldn't get that card working until PNP
was off in the bios.
Note that since this is Debian, make-kpkg is probably preferred to the
basic "make bzImage; make modules; make modules-install".
Mike
Attachment:
pgp72Q2NNnhWW.pgp
Description: PGP signature