Framebuffer aty128fb - halfway
i compiled kernel-2.2.19 to set up framebuffer dev.
during boot up kernel recognizes the card properly and
sets the default mode with 80x30 console screen.
so far good, however, i would love to use some xxx x yyy console
after all this is why i started this job on the first place.
so i started to play with fbset and lilo append
with some funny outcome:
1) lilo append:
i tried several different cmdline versions eg.:
video=aty128fb:mode:1024x768,...
video=aty128fb:xres:1024,yres:768,....
or
video=aty128fb:1024x768-8@60 as suggested in the kernel-2.4.4
documentation of aty128
with "vga=792"
the kernel boots and sets fb again and again to the default
640x480...
2) fbset:
i can set any mode defined in /etc/fb.modes and the console
first looks OK and works OK in a pure "forward" mode
but if i start editing or searching back in the history
the cursor disappears and editing do not show up
on the other hand, midnight commander works absolutely fine and looks
gorgeous ;-)
can anyone, please, tell me what could be the problem?
thanks,
imre
Reply to: