--- Begin Message ---
Hi there.
Installing new packages via dselect doesn't work
anymore for me but I have no idea were to start
looking for clues, so I just post the output,
with a few comments.
I can provide further information if necessary.
-- I already selected some packages and went for install: --
Reading Package Lists... Done
Building Dependency Tree... Done
Correcting dependencies... Done
The following packages will be REMOVED:
libnasl0 libnessus0 tetex-lib
The following NEW packages will be installed:
-- snip --
281 packages upgraded, 102 newly installed, 3 to remove and 0 not upgraded.
Need to get 0B/203MB of archives. After unpacking 52.1MB will be used.
Do you want to continue? [Y/n]
perl: warning: Setting locale failed.
perl: warning: Please check that your locale settings:
LANGUAGE = (unset),
LC_ALL = (unset),
LC_CTYPE = "de_DE",
LANG = "C"
are supported and installed on your system.
perl: warning: Falling back to the standard locale ("C").
-- It starts scanning now and stops at 85% --
85% [Scanning packages]Template parse error near "" at /usr/lib/perl5/Debian/DebConf/Template.pm line 102, <TEMPLATES> chunk 2.
E: Sub-process /usr/sbin/dpkg-preconfigure --apt returned an error code (29)
E: Failure running script /usr/sbin/dpkg-preconfigure --apt
Some errors occurred while unpacking. I'm going to configure the
packages that were installed. This may result in duplicate errors
or errors caused by missing dependencies. This is OK, only the errors
above this message are important. Please fix them and run [I]nstall again
Press enter to continue.
installation script returned error exit status 100.
Press <enter> to continue.
-- Back at the dselect frontend, nothing installed or done. --
Thanks for your help,
Nikolai.
--
------------------------------------------------------
+-----------------+
| Escape the |
| Gates of hell. | Debian GNU/Linux
| | http://www.debian.org
| Use Linux. |
+-----------------+
------------------------------------------------------
--- End Message ---