RE: D-Link DFE-530TX Probs W. 2.4.2
--- "Rick Commo" <Rick.Commo@verizon.net>
> wrote:
>I am not using kernel 2.4.2, but the driver that I selected was rtl8139.o.
I think there are 2 versions. Older ones like mine use the via-rhine driver.
I don't have a file called modules.config. I have a file called /etc/modules.conf but there is no mention of eth0 in there.
>Even with that I had some problems until I edited the modules.config file.
>It has a line right after the eth0 alias that was "options irq=10". Once I
>removed that all was well.
>
>-rick
>
>
>-----Original Message-----
>From: David Frey [mailto:slacker_x@detonate.net]
>Sent: Saturday, February 24, 2001 8:16 PM
>To: debian-user@lists.debian.org
>Subject: D-Link DFE-530TX Probs W. 2.4.2
>
>
>I just compiled a 2.4.2 kernel. The compile went fine. Ran lilo,
>rebooted...everything looking good. The big problem is that my NIC (a
>D-Link DFE-530TX) doesn't work. I would like to elaborate on "doesn't
>work", but I'm afraid I can't. I did cat /proc/pci and the NIC was listed
>there. I noticed that it was sharing IRQ 10 with my USB controller, but I
>was told by someone in #debian on IRC that it wouldn't be an issue because I
>have USB disabled in my kernel. The driver that I have compiled into my
>kernel is via-rhine. I am sure this is the right driver. This NIC has been
>used under win 95, 98 redhat 6.1 and debian. I have tried a couple times to
>get this NIC to work with kernels I have built, but it never does. Another
>thing that might be important is that this is a revision A board. I've
>heard that rev B boards had some issues. Thanks, David Frey
>
>_____________________________________________________________
>Wake up screaming. . . http://www.detonate.net/
>
>
>--
>To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
>with a subject of "unsubscribe". Trouble? Contact
>listmaster@lists.debian.org
_____________________________________________________________
Wake up screaming. . . http://www.detonate.net/
Reply to: