Re: Problems installing Netgear FA311 Ethernetcard.
At 11:49 AM 1/22/01 , you wrote:
My Netgear FA311 Card was not found at bootstrapping (rescue disk).
I were not able to install the recommended 'tulip' driver into the kernel at
I wanted to install the 'tulip' driver as a module, after I build my system,
but /dev/eth0 did not exists.
Enable the National Semiconductor (natsemi.c) ethernet driver in the kernel
under network devices. Install the new kernel, then add a line to
/etc/network/interfaces for eth0. Boot back up and it should be
working. Promise it'll work, I just got through doing it.