Re: HD Problems...!!!!
On 06 Jun 2000, Vitux wrote:
> Larry Shields wrote:
> >
> > I am not sure if anyone can help me out with this problem or not, but here
> > is what happened this morning...
> >
> > When I turned on the monitor, there were a bunch of error's on the screen,
> > my 6.4hd keep'ed trying to be accessed, but it could'nt...Here is what it
> > was showing on the screen...
> >
> > hda: read_intr: Status=0x59 {DriveReadySeekCompleteDataRequest ERROR}
> > hda: read_intr: Error 0x10 {SectorNotFound}LBAsect=4193029, sector=64
> >
> > Has anyone had a problem like this...??? If so what can I do to correct the
> > problem, other than sending the HD back to Western Digital to see if they
> > can fix it without loosing any of my data on the hardrive...
> >
> > Any help on this would be appreicated, Thanks...
> >
> > Larry Shields WD9ESU
> > AMPRnet: wd9esu.ampr.org IPaddr 44.92.0.60
> > E-Mail: larrysh@chorus.net
> > ICQ:6221703
> >
> >
> >
> I get the same kind of errors with an older WD drive. There
> have been quite a few reports on the list about this.
> I believe it has to do with apm/bios spinning the drive down
> and back up again: If I set the drive to never spin down
> (hdparm -S0 /dev/hdx), it never complains.
> The error occurs when the system is waiting for the drive to
> get back up again. Sometimes, it will take a minute or two,
> then all will be fine, sometimes I have to shut the thing down
> with ctrl-alt-del, which usually takes about an hour, and the
> drive is fsck'ed on reboot.
> The solution I've found after a complete and a partial
> disk-crash is: avoid WD drives. Some of them (even new) are
> faulty, some aren't. The alternative is to stop them from
> shutting down with the hdparm-command.
> hth
> Vitux
>
I've had very similar messages (can't remember exactly) from my CD drive
on a Toshiba Satellite 4000CDT. I even got Toshiba to replace the drive
under warranty, but it still happened once after that. However, it isn't
happening at present and I hope it doesn't recur. I thought it might
also be the CD disk, because it seemed to happen with some disks more
than others. But now I wonder whether it had something to do with the
kernel I was using at the time (can't remember which), because it
doesn't seem to happen with the latest (2.2.15).
In fact, I also have an older computer, with a very downmarket and slow
CD drive, which also gave this message and which I'd written off in
consequence; however, this too is now working, rather mysteriously,
again with the latest kernel.
Anthony
--
Anthony Campbell - running Linux Debian 2.1 (Windows-free zone)
Book Reviews: http://www.pentelikon.freeserve.co.uk/bookreviews/
Skeptical articles: http://www.freethinker.uklinux.net/
"To be forced by desire into any unwarrantable belief is a calamity."
I.A. Richards
Reply to: