HP Colorado 8GB IDE tapestreamer
Hi,
I've problems getting the HP Colorado 8GB IDE tapestreamer to work.
Using ide-tape, i get I/O errors after +/- 5000 blocks writing,
reading gives a I/O error too, it doesnt' read any blocks. mt status
doesn't work either.
I use the /dev/(n)ht0 devices.
Ide-scsi seems to work ok, mt status appears to work, but writing
results in a read-only filesystem error...
reads are resulting in an I/O error too in ide-scsi mode
It's primary slave on an old (486) IDE controller, together with an
IDE HD.
Some dmesg entries:
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
scsi : 1 host.
Vendor: HP Model: COLORADO 8GB Rev: 2.08
Type: Sequential-Access ANSI SCSI revision: 02
st: bufsize 32768, wrt 30720, max buffers 5, s/g segs 16.
Detected scsi tape st0 at scsi0, channel 0, id 0, lun 0
st0: Error with sense data: Info fld=0x40, Current st09:00: sense key Medium Error
st: Unloaded.
scsi : 0 hosts.
ide-tape: hdb: overriding capabilities->speed (assuming 650KB/sec)
ide-tape: hdb: overriding capabilities->max_speed (assuming 650KB/sec)
ide-tape: hdb <-> ht0, 650KBps, 16*32kB buffer, 3200kB pipeline, 250ms tDSC
ide-tape: ht0: I/O error, pc = a, key = 7, asc = 27, ascq = 0
ide-tape: Couldn't write a filemark
--
,-------------------------------------------.
> Name: Alson van der Meulen <
> Personal: alson@linuxfreak.nl <
> School: alson@gymnasiumleiden.nl <
`-------------------------------------------'
Terminated??!
---------------------------------------------
Reply to: