Re: forcing D-Link 530 into Full-Duplex
try using the RT1839 driver instead ???
http://www.linux-1U.net....3 NIC 1Us.....1U Raid5....
On 29 Sep 2000, Arcady Genkin wrote:
> I have a D-Link 530 card using a compiled-in via-rhine driver as eth0.
> The card is talking to an identical card in a computer that runs
> FreeBSD. I'm seeing collisions on the Linux side of the link, and am
> wondering what parameters I should pass the kernel to force the card
> into Full-duplex 100base mode, and how to pass those params. (I
> already did that on the FreeBSD side).
> FWIW, here's the output from ifconfig and dmesg:
> ,----[ dmesg ]
> | via-rhine.c:v1.01 2/27/99 Written by Donald Becker
> | http://cesdis.gsfc.nasa.gov/linux/drivers/via-rhine.html
> | eth0: VIA VT3043 Rhine at 0xe800, 00:50:ba:a9:13:f6, IRQ 10.
> | eth0: MII PHY found at address 8, status 0x782d advertising 05e1 Link 0000.
> | PCI latency timer (CFLT) is unreasonably low at 32. Setting to 64 clocks.
> ,----[ ifconfig ]
> | eth0 Link encap:Ethernet HWaddr 00:50:BA:A9:13:F6
> | inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
> | UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> | RX packets:448934 errors:0 dropped:0 overruns:0 frame:0
> | TX packets:266302 errors:0 dropped:0 overruns:0 carrier:0
> | collisions:7766 txqueuelen:100
> | Interrupt:10 Base address:0xe800
> Arcady Genkin
> Don't read everything you believe.
> Unsubscribe? mail -s unsubscribe firstname.lastname@example.org < /dev/null