Re: Unidentified subject!
On Fri, Feb 11, 2000 at 04:58:33AM +0000, Lars Sander-Green wrote:
> I installed the latest version of the base Debian system on an old 486 today
> (clean system). The installation seemed to work fine, but when I tried to
> boot from the hard disk, the letters LI appeared and the system froze. I
[...]
>From file:/usr/share/doc/lilo/Manual.txt.gz:
LI The first stage boot loader was able to load the second stage boot
loader, but has failed to execute it. This can either be caused by a
geometry mismatch or by moving /boot/boot.b without running the map
installer.
The map installer is the lilo command you run under linux.
The description of the 1024-cylinder problem is also in
that documentation file.
Johan Ur Riise
Reply to: