Re: 3COM905B 10/100 Ethernet Config
If you are using Frozen from January 27 the boot disks had problems.
They have now been corrected.
Try switching slots...
On Tue, 8 Feb 2000, Todd Suess wrote:
> Greetings,
>
> I installed a new 3COM Ethernet Card into my Debian Box in preparation
> for the install of my cable modem in a week or so, and after recompiling the
> kernel (2.2.14) with the correct Ethernet Driver, during bootup the card
> does not
> seem to be sensed at all, and no eth0 device gets created. I can do a
> lspci on the
> card, and this is the output, if that is helpful at all.
>
> Any suggestions on how to get this beast working would be
> appreiciated. According to
> the Ethernet HOWTO if the driver is installed it should automagically
> detect the card
> and no /dev entry is required, I should just be able to do ifconfig and see
> a new
> interface called eth0.
>
> Regards,
>
> Todd
>
> blackhole:~# lspci
>
> <irrelevant stuff snipped>
>
>
> 00:0a.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone]
> (rev 30)
> Subsystem: 3Com Corporation: Unknown device 9055
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR+
> Latency: 10 min, 10 max, 64 set, cache line size 08
> Interrupt: pin A routed to IRQ 10
> Region 0: I/O ports at 6800
> Region 1: Memory at e8000000 (32-bit, non-prefetchable)
> Capabilities: [dc] Power Management version 1
> Flags: PMEClk- AuxPwr- DSI- D1+ D2+ PME-
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
> blackhole:~#
>
>
> --
> Unsubscribe? mail -s unsubscribe debian-user-request@lists.debian.org < /dev/null
>
Reply to: