Re: xntpd not functioning anymore...
Henrique M Holschuh wrote:
>
> On Mon, 13 Dec 1999, Dan Hugo wrote:
> > $ntptrace tock.cs.unlv.edu
> > tock.CS.UNLV.EDU: stratum 2, offset 0.853196, synch distance 0.04726
> > usno.pa-x.dec.com: stratum 1, offset 0.842812, synch distance 0.02371,
> > refid 'USNO'
>
> Those offset lines are worrisome. NTP does not deal well with large offsets
> and delay (round-trip time) by design (it would be pointless, you can't sync
> over such a link), and will promptly exit if it gets worse than 1s. You're
> at 0.8s already, and that's way too high.
>
> One thing you -must- do when you have such a bad sync is to run ntpdate in
> the same server-set you will run ntp against right before you start ntp.
> Debia potato gets this right, don't know about slink.
I do run ntpdate in /etc/init.d/xntp3
That is interesting about the round-trip time. I will try to find some
servers closer.
But here is the interesting part:
Machines inside my masqueraded network can see tock just fine (I
determined this by pointing one machine inside at tock, rather than
pointing it at my xntpd+masquerade machine), which really points at
ipchains being bad...
> > I am not sure where to look now. I believe that ipchains is configured
> > to allow ntp to communicate, but I could be wrong. I am suspicious of
> > my ipchains config.
>
> Don't kill tcp or udp packets from/to the ntp service port, nor delay them.
> When in doubt, try ntpq -p <host> to "ping" the servers.
Interesting.
I have tock as the first server listed in the masq machine's ntp.conf
file. On the machine inside, I see from /var/log/xntpd
13 Dec 03:09:07 xntpd[26296]: synchronized to 131.216.18.4, stratum=3
But not such message in the log file on the outside machine.
BUT, running ntpq -p 131.216.18.4 on the outside machine:
remote refid st t when poll reach delay
offset disp
==============================================================================
.207.247.149.141 timekeeper.isi. 2 u 360 1024 366 208.04 22.500
282.15
+castor.nevada.e clepsydra.dec.c 2 u 77 128 377 -0.35
-1.698 2.49
-vegas.engineeri clock.isc.org 2 u 770 1024 356 65.86 90.993
24.80
-shell2.astreet. clepsydra.dec.c 2 u 43 128 372 68.07 68.881
21.59
x155.178.210.11 tgf_s1.ntp.tc.f 2 u 20 64 376 939.77 412.093
32.00
xsulu.hfl.tc.faa 172.26.251.9 2 u 65 64 376 695.30 267.309
76.61
.astreet.com clepsydra.dec.c 2 u 11 64 277 56.00 92.711
15.49
-fe01-r01-core.t 132.163.135.130 2 u 110 256 377 138.44 32.125
16.57
xgw.decide2act.c clepsydra.dec.c 2 u 136 64 374 187.67 -1924.9
885.97
-blackcomb.sfu.c tick.usno.navy. 2 u 194 512 377 121.61 -34.844
34.35
-whistler.sfu.ca tick.usno.navy. 2 u 25 512 177 123.72 -29.541
104.80
<ctrl-C>
and ntptrace 131.216.18.4
tock.CS.UNLV.EDU: stratum 2, offset 0.978212, synch distance 0.11465
haven.umd.edu: stratum 1, offset 0.976242, synch distance 0.01128, refid
'WWVB'
> Also, just to be sure... you did notice debian potato packages ntp V4 (don't
> know about slink), and used the proper "version 3" strings after the servers
> in /etc/ntp.conf for any debian potato machines, didn't you?
I am using xntp3 from slink... though I even tried ntpdate -o[1,2,3]
with no real difference on the outside machine.
Reply to: