Lost PCI Network card after potato upgrade.
Hello, I will try this question again without the attempt at humor...
I upgraded my slink system to potato using dselect 3-4 days ago. After
the initalruns through dselect/install/config/remove there weretwo
problems still being reported.
#1 the gcc deb file would not load because of a conflicht with an old
libg++.
#2 setserial would not configure.
I removed the old libg++272 (I think that was its name) and gcc seemed
to install fine.
The error messages during the configureation of setserial said that my
modules needed to be updated and to run
"update-module force" and run configure again. Well, I did this and the
above listed fix and now my network card is no longer detected. (Note:
I noticed the problem after I rebooted the system so I am not sure
exactly what is causing this.
I looked in my /var/log/kern.log file and found these differences before
and after the reboot.
The last line in this file has the line (note: the *date systemname* is
acutially the date time and systemname at the time of the reboot. I
just didn't feel like typing it all in each time).
*date systemname* kernel: ne.c No PCI cards found. use "io=0xNNN" values
for ISA cards.
Prior to the problem (earlier in the file) I had the following:
*date systemname* kernel: ne.c v1.10 9/23/94 Donald Becher (*email
address*)
*date systemname* kernel: NE*000 ethercard probe at 0x300 00 50 4e 03 8b
d6
*date systemname* kernel: eth0: NE2000 found at 0x300 using IRQ 3
Does anyone have an idea of what I did? How can I get my networking
re-activated?
Thank you for your time,
Doug Thistlethwaite
Reply to: