Sparc PPPconfig problem
I have Debian on my Acer Aspire and it is working just great... I
used to have a jaz drive hooked up to my Sun Sparc IPC which I used to
run Linux off of the jaz drive... This was back in December and I had
no problem with it. Now that I don't see a reason to use Solaris
anymore since it's so slow I figured to just put Debian on the hard
drive. I installed the base and I had two problems. Now I have
installed Debian a lot of times in the past so I pretty much now if I'm
doing something wrong. The first thing I noticed was when I installed
the drivers floppy it had an error saying.... sed not found sed not
found and so on. I had no clue what sed is but I know they was no
drivers in the drivers section. I wasn't to worried about that since I
don't have any unregular hardware. When I got to the ppp part of my set
which I use Chap PPP to install. I have two phone lines so I have no
problem with the 25 hours of downloading. But the problem is I can only
stay connected to any ISP for no more then 2 min. I looked and looked
to see if I had something set up wrong but could not find any. In those
2 min. I can ftp , telnet, ping, etc. just find. But the modem will
still kick off in about 2 min. I have tried connected to different ISP
but still it disconnects. My older version of Debian which I still have
on my jaz disk that I can runs fine with PPP but it needs updated
badly. I have my jaz drive hooked up to a different computer now so I
need to know what is wrong with the PPPConfig, and what is this sed not
found when I install my drv1400.bin.
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
Reply to: