colormap problem
My computer has 96Meg, the Diamond 3D has 4Meg. However, I always get
colormap problem. Look at printout of startx, and I found I was only
using 6 bit per RGB. All I specified in XF86Config is 8, 16,
etc. Seems I'm out of luck to get more colormaps...
Thanks.
Jinsong
----------------------------
(--) S3V: PCI: ViRGE rev 5, Linear FB @ 0xe0000000
(--) S3V: card type: PCI
(--) S3V: chipset: ViRGE rev. 5
(--) S3V: chipset driver: s3_ViRGE
(--) S3V: videoram: 4096k
(--) S3V: Ramdac type: s3_trio64
(--) S3V: Ramdac speed: 135 MHz
(--) S3V: Using Trio32/64 programmable clock (MCLK 54.886 MHz)
(--) S3V: Maximum allowed dot-clock: 135.000 MHz
(**) S3V: Mode "1024x768": mode clock = 85.000
(--) S3V: Operating RAMDAC in pixel multiplex mode
(--) S3V: Using 6 bits per RGB value
(**) S3V: Virtual resolution set to 1024x768
(--) S3V: Local bus LAW is 0xE00xxxxx
(--) S3V: Using a banksize of 4096k, line width of 1024
Reply to: