Re: Swap partition and fdisk
> My simple formula
> swap needed = total memory need - physical memory size
> works much better than the "twice physical memory" one.
Questionable. Aside from not being computable (everyone can easily
tell what their physical memory size is, but few people know how much
their "total memory need" is going to be when they're installing
Linux) and vaguely defined (the unqualified term "memory" should
almost never be used to mean anything but physical memory), it's not
really accurate if by "total memory need," you mean "total VM space
needed." The kernel takes up a chunk of wired memory for its own
needs, and if less than, say, 10% of physical memory is available for
buffering files on top of that, your performance is going to go
through the floor.
There's another, insidious problem with many VM systems (I don't
honestly know if Linux's is included) that affects the above
computation. Let's say I have 32MB of physical memory and 24MB of
swap, and let's pretend that a constant 8MB of my physical memory is
consumed by disk buffers and kernel overhead. Okay, you say, now I
have 48MB of virtual memory to play with.
Now let's say that all of the running processes on my system are
long-running processes, and they consume a total of 25MB of virtual
memory. Obviously, at any given time, a minimum of 1MB of that data
has been paged out. Let's say that at some time we have 24MB of the
pages resident and 1MB of swap space allocated to hold the 1MB of data
that's been paged out. Now say that that 1MB needs to be paged back
in. The system needs to page out another 1MB of data, so it allocates
another 1MB of swap space and pages it out. (Obviously, this all
happens one page at a time.) Now, here's the catch: under most VM
systems, the old 1MB of swap space remains allocated for the old data
in order to save time if those pages need to be swapped out again and
haven't been dirtied by writes. So now we have 24MB resident and 2MB
of swap space allocated. We can keep going this way, paging in the
data that was just paged out, until finally the last 1MB of data needs
to be paged out and all of the swap space has been allocated.
At this point, a clever VM system will deallocate swap pages which
aren't strictly needed in order to make room. But the VM systems I
have experience with will simply fail catastrophically. So with only
25MB of data, we can swamp what was theoretically a 48MB playground.
Even if the VM system is clever, your performance may (depending on
your applications) go through the floor if your total amount of data
exceeds the amount of swap space on disk, because it reduces your
ability to leave paged-in data on disk and forces you to write pages
out to disk which you would otherwise not need to write.
My conclusion: allocate as much swap space as you believe your virtual
memory needs will be. For most applications, twice your physical
memory size is about the upper limit you can use without thrashing.
Reply to: