kablosuz ağ
Merhaba,
ADSL üzerinden kablolu olarak internete bağlanırken rahat battı ve
kablosuz kullanmak istedim. ADSL cihazı ve kablosuz PCMCIA adaptörü
AirTies marka. Aşağıda cihaz ve programlar ile ilgili çıktılar var.
*********************************
$lspci
0000:06:00.0 Network controller: Intersil Corporation Intersil ISL3890
[Prism GT/Prism Duette] (rev 01)
PCI: Enabling device 0000:06:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:06:00.0[A] -> Link [LNKF] -> GSI 11 (level,
low) -> IRQ 11
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_reset: failure
$dpkg -l ndis*
Desired=Unknown/Install/Remove/Purge/Hold
|
Status=Not/Installed/Config-files/Unpacked/Failed-config/Half-installed
|/ Err?=(none)/Hold/Reinst-required/X=both-problems (Status,Err:
uppercase=bad)
||/ Name Version Description
+++-===================-===================-======================================================
un ndiswrapper-modules <none> (no description available)
ii ndiswrapper-modules 1.1-4+2.6.12-10 Ndiswrapper linux kernel
module
ii ndiswrapper-source 1.1-4 Source for the ndiswrapper
linux kernel module
ii ndiswrapper-utils 1.1-4 Userspace utilities for
ndiswrapper
#ndiswrapper -l
Installed ndis drivers:
fa4i01a driver present, hardware present
*******************************************************
Firmware yüklemesi yapamıyorum diyor.
Knoppix 4.0 ile driver yüklendikten sonra;
eth0: resetting device...
eth0: uploading firmware...
eth0: firmware version: 1.0.4.3
eth0: firmware upload complete
eth0: no 'reset complete' IRQ seen - retrying
eth0: no 'reset complete' IRQ seen - retrying
eth0: interface reset failure
prism54: Your card/socket may be faulty, or IRQ line too busy :(
böyle bir uyarı ile çalışmıyor.
Nasıl kablosuz olabilirim?
Teşekkürler, İyi çalışmalar..
--
Zeki Çatav
http://kalpdamar.hekimi.com
Reply to: