Máscara de red errada
Hola a todos
Les cuento mi problema, deseo configurar mi dirección IP de la siguiente
manera:
/etc/network/interfaces
auto lo
iface lo inet loopback
# The primary network interface
auto eth0
iface eth0 inet static
address 200.xxx.xx.86
netmask 255.255.225.192
network 200.xxx.xxx.64
broadcast 200.xxx.xxx.127
gateway 200.xxx.xxx.90
dns-nameservers 200.xxx.xxx.100
Pero tal configuración no tiene efecto al verla con ifconfig (en la
máscara de red):
ifconfig
eth0 Link encap:Ethernet HWaddr 00:12:72:29:29:CD
inet addr:200.xxx.xxx.86 Bcast:200.xxx.xxx.127 Mask:255.255.255.0
inet6 addr: fe80::216:76ff:fe29:29cd/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1087 errors:0 dropped:0 overruns:0 frame:0
TX packets:708 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:97378 (95.0 KiB) TX bytes:66586 (65.0 KiB)
¿alguien podría decirme que hago mal?
Notas:
*cuando ejecuto ifconfig por mi cuenta con las direcciones apropiadas si
adopta la máscada adecuada, pero el servicio /etc/init.d/networking NO.
*uname -a 2.6.18-4-686 #1 SMP Wed May 9 23:03:12 UTC 2007 i686 GNU/Linux
*distribución debian estable/etch
dmesg | grep eth
e100: eth0: e100_probe: addr 0xff500000, irq 66, MAC addr 00:12:72:29:29:CD
e100: eth0: e100_watchdog: link up, 100Mbps, half-duplex
eth0: no IPv6 routers present
Reply to: