K3b me da buffer underrun
Buenas. Desde hace algunos días no puedo grabar, ya que la grabación siempre se termina parando por un buffer underrun en cualquier momento. Y tengo el burnfree activado y la grabadora lo soporta. Os paso la salida de una de esas grabaciones.
------------------------------------------------------------------------
System
-----------------------
K3b Version: 0.11.9
KDE Version: 3.2.2
QT Version: 3.2.3
cdrecord
-----------------------
scsidev: '/dev/hdc'
devname: '/dev/hdc'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
Linux sg driver version: 3.5.27
SCSI buffer size: 64512
Cdrecord-Clone 2.01a27 (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling
NOTE: this version of cdrecord is an inofficial (modified) release of cdrecord
and thus may have bugs that are not present in the original version.
Please send bug reports and support requests to <cdrtools@packages.debian.org>.
The original author should not be bothered with problems of this version.
TOC Type: 1 = CD-ROM
Using libscg version 'schily-0.8'.
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identifikation : 'CD-RW GCE-8525B '
Revision : '1.02'
Device seems to be: Generic mmc CD-RW.
Current: 0x000A
Profile: 0x000A (current)
Profile: 0x0009
Profile: 0x0008
Profile: 0x0002 (current)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-2 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1951488 = 1905 KB
FIFO size : 52428800 = 51200 KB
Track 01: data 676 MB
Total size: 776 MB (76:57.34) = 346301 sectors
Lout start: 777 MB (76:59/26) = 346301 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 6
Reference speed: 2
Is not unrestricted
Is erasable
ATIP start of lead in: -11078 (97:34/22)
ATIP start of lead out: 359849 (79:59/74)
1T speed low: 0 (reserved val 0) 1T speed high: 4
2T speed low: 0 (reserved val 5) 2T speed high: 0 (reserved val 12)
power mult factor: 3 5
recommended erase/write power: 3
A1 values: 02 3A B0
A2 values: 5C C6 26
Disk type: Phase change
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 13548
Starting to write CD/DVD at speed 4 in real SAO mode for single session.
Last chance to quit, starting real write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Performing OPC...
Sending CUE sheet...
/usr/bin/cdrecord: WARNING: Drive returns wrong startsec (0) using -150
Writing pregap for track 1 at -150
Starting new track at sector: 0
Track 01: 0 of 676 MB written.
Track 01: 1 of 676 MB written (fifo 99%) [buf 97%] 5.7x.
Track 01: 2 of 676 MB written (fifo 100%) [buf 100%] 0.2x.
(OS AHORRO TODO ESTO QUE ES LO MISMO
Track 01: 233 of 676 MB written (fifo 0%) [buf 79%] 1.0x.
Track 01: 234 of 676 MB written (fifo 0%) [buf 80%] 3.3x.
Track 01: 235 of 676 MB written (fifo 0%) [buf 63%] 2.1x.
/usr/bin/cdrecord: Success. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 01 D7 0E 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 71 00 05 00 00 00 00 0A 00 00 00 00 21 02 00 00
Sense Key: 0x5 Illegal Request, deferred error, Segment 0
Sense Code: 0x21 Qual 0x02 (invalid address for write) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63488
cmd finished after 0.020s timeout 200s
/usr/bin/cdrecord: The current problem looks like a buffer underrun.
/usr/bin/cdrecord: It looks like 'driveropts=burnfree' does not work for this drive.
/usr/bin/cdrecord: Please report.
/usr/bin/cdrecord: Make sure that you are root, enable DMA and check your HW/OS set up.
write track data: error after 246968320 bytes
Writing time: 562.546s
Average write speed 8.3x.
Min drive buffer fill was 16%
Fixating...
Fixating time: 0.001s
/usr/bin/cdrecord: fifo had 3987 puts and 3891 gets.
/usr/bin/cdrecord: fifo was 261 times empty and 25 times full, min fill was 0%.
BURN-Free was 39 times used.
cdrecord comand:
-----------------------
/usr/bin/cdrecord.mmap -v gracetime=2 dev=/dev/hdc speed=52 -dao driveropts=burnfree -eject fs=50m -data -tsize=346301s -
mkisofs
-----------------------
346301
INFO: ISO-8859-15 character encoding detected by locale settings.
Assuming ISO-8859-15 encoded filenames on source filesystem,
use -input-charset to override.
Using EXPEDIENTE_X___TEMPORADA000.AVI;1 for /Expediente X - Temporada 1 - Capitulo 04 Conducto.avi (Expediente X - Temporada 1 - Capitulo 03 Escurridizo.avi)
Using EXPEDIENTE_X___TEMPORADA001.AVI;1 for /Expediente X - Temporada 1 - Capitulo 03 Escurridizo.avi (Expediente X - Temporada 1 - Capitulo 02 Garganta profunda.avi)
0.15% done, estimate finish Sun Apr 18 18:56:53 2004
0.29% done, estimate finish Sun Apr 18 19:09:11 2004
0.43% done, estimate finish Sun Apr 18 19:05:41 2004
0.58% done, estimate finish Sun Apr 18 18:51:58 2004
0.73% done, estimate finish Sun Apr 18 18:41:47 2004
0.87% done, estimate finish Sun Apr 18 18:42:38 2004
(Y TODO ESTO)
35.52% done, estimate finish Sun Apr 18 18:38:02 2004
35.66% done, estimate finish Sun Apr 18 18:38:02 2004
mkisofs comand:
-----------------------
/usr/bin/mkisofs -gui -graft-points -V K3b data project -volset -A K3B THE CD KREATOR VERSION 0.11.6 (C) 2003 SEBASTIAN TRUEG AND THE K3B TEAM -P -p K3b - Version 0.11.6 -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-sotanez/k3bBE0yja.tmp -r -hide-list /tmp/kde-sotanez/k3bLtIh6b.tmp -J -hide-joliet-list /tmp/kde-sotanez/k3bj4tWgb.tmp -l -iso-level 2 -path-list /tmp/kde-sotanez/k3bZJ2fSb.tmp
------------------------------------------------------------------------
No se cual puede ser el fallo, nunca me había pasado. En windows con el nero se graba bien. Saludos.
--
"No hay nada peor que ser vulgar"
sotanez@jabber.cn
Reply to: