Kpilot -> Palm 515
Galera,
Estou tentando sincronizar meu palm m515 com o Kde 3.2 com Kernel 2.4.18 não
estou com sorte porque ocorre alguns erros como:
"could not open device /dev/ttyUSB0"
Meu ttyUSB0 esta com 777.
ai eu dou um dmesg e aparece isso:
hub.c: USB new device connect on bus1/1, assigned device number 2
usb.c: USB device 2 (vend/prod 0x830/0x3) is not claimed by any active driver.
usb.c: USB disconnect on device 2
hub.c: USB new device connect on bus1/1, assigned device number 3
usb.c: USB device 3 (vend/prod 0x830/0x3) is not claimed by any active driver.
Vejo se o Linux encontrou o Palm com o comando cat /proc/bus/usb/devices
e sai isso
T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=12 MxCh= 2
B: Alloc= 0/900 us ( 0%), #Int= 0, #Iso= 0
D: Ver= 1.00 Cls=09(hub ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0000 ProdID=0000 Rev= 0.00
S: Product=USB UHCI Root Hub
S: SerialNumber=e000
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr= 0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=255ms
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 6 Spd=12 MxCh= 0
D: Ver= 1.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=16 #Cfgs= 1
P: Vendor=0830 ProdID=0003 Rev= 1.00
S: Manufacturer=Palm, Inc.
S: Product=Palm Handheld
S: SerialNumber=00RPP742A4KW
C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 2mA
I: If#= 0 Alt= 0 #EPs= 4 Cls=ff(vend.) Sub=00 Prot=00 Driver=(none)
E: Ad=81(I) Atr=02(Bulk) MxPS= 16 Ivl= 0ms
E: Ad=01(O) Atr=02(Bulk) MxPS= 16 Ivl= 0ms
E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
Pelo visto ele encontrou mas não sincroniza, estou com o modulo usbserial e o
visor carregado.
Me ajudem!!
Gustavo
Reply to: