Duas Placas de Rede.
Ola Amigos,
Eu espetei outra placa de rede aqui no debian potato! :)
Inseri o modulo e fiz as configs no /etc/network/interfaces ficando assim:
Debian:~# cat /etc/modules
# /etc/modules: kernel modules to load at boot time.
#
# This file should contain the names of kernel modules that are
# to be loaded at boot time, one per line. Comments begin with
# a #, and everything on the line after them are ignored.
rtl8139
ne2k-pci
ps.: Uma placa eh uma Realtek8139 (rtl8139.o) e a outra um Realtek8129(AS)
(ne2k-pci).
Debian:~# cat /etc/network/interfaces
# /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)
# The loopback interface
iface lo inet loopback
# Config da eth0
iface eth0 inet static
address 192.168.151.2
netmask 255.255.255.0
network 192.168.151.0
broadcast 192.168.151.255
gateway 192.168.151.1
# config da eth1
iface eth1 inet static
address 192.168.151.3
netmask 255.255.255.0
network 192.168.151.0
broadcast 192.168.151.255
gateway 192.168.151.1
Parece estar tudo correto nao ??
Inclusive as placas sao detectadas. Veja:
eth0: RealTek RTL8139 Fast Ethernet at 0x1800, IRQ 5, 00:e0:7d:c5:1b:54.
eth1: RealTek RTL-8029 found at 0x1440, IRQ 10, 00:00:21:FC:4E:E4.
A tabela de rotas tmb parece estar certa:
Debian:~# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
0.0.0.0 192.168.151.1 0.0.0.0 UG 0 0 0 eth0
Debian:~#
Pra desencargo de consiencia (mesmo sabendo que nao tem nada a ver) eu
coloquei a rota default pra eth1 tmb!
Debian:~# route add default gw 192.168.151.1 dev eth1
Debian:~# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
0.0.0.0 192.168.151.1 0.0.0.0 UG 0 0 0 eth1
0.0.0.0 192.168.151.1 0.0.0.0 UG 0 0 0 eth0
Debian:~#
Eh mesmo assim eu pingo a 192.168.151.3 (que eh a eth1) e nao responde o
ping. E nem a eth2 consegue pingar ninguem da rede! :/
Algeum sabe pq isso ta acontecendo ??
Esqueci de fazer alguma coisa ??
Obrigado.
t+
[ ]'s
Use Your Hadrion WebMail too!
Access: <A href=http://www.hadrion.com.br/>http://www.hadrion.com.br</A>
Doubts? <A href=mailto:wendel@hadrion.com.br>wendel@hadrion.com.br</A>
________________________________________________
This mail was sent by Hadrion WebMail 1.0
Reply to: