Brak sieci z nowym kernel'em
Witam,
Po kompilacji 2.4.20 nie działa mi sieć. Sterowniki do karty D-Link DRN-32TX
rozpoznaje raczej prawidłowo:
Jan 24 18:42:36 burdy kernel: Real Time Clock Driver v1.10e
Jan 24 18:42:36 burdy kernel: 8139too Fast Ethernet driver 0.9.26
Jan 24 18:42:36 burdy kernel: PCI: Found IRQ 11 for device 00:0d.0
Jan 24 18:42:36 burdy kernel: eth0: RealTek RTL8139 Fast Ethernet at
0xc9836000, 00:50:ba:5b:71:ea, IRQ 11
Jan 24 18:42:36 burdy kernel: eth0: Identified 8139 chip type 'RTL-8139C'
Jan 24 18:42:36 burdy kernel: Serial driver version 5.05c (2001-07-08) with
MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
Jan 24 18:42:36 burdy kernel: ttyS00 at 0x03f8 (irq = 4) is a 16550A
Jan 24 18:42:36 burdy kernel: ttyS01 at 0x02f8 (irq = 3) is a 16550A
Jan 24 18:42:36 burdy kernel: eth0: Setting half-duplex based on
auto-negotiated partner ability 0000.
Jan 24 18:42:37 burdy modprobe: modprobe: Can't locate module
char-major-10-134
Jan 24 18:42:38 burdy lpd[548]: restarted
Wszystko powinno być cacy, jednak połączenia Ineternetem nie ma. Wydaje mi
się, że jakichś modułów jest za mało:
burdy:/var/log# dhclient-2.2.x
Internet Software Consortium DHCP Client 2.0pl5
Copyright 1995, 1996, 1997, 1998, 1999 The Internet Software Consortium.
All rights reserved.
Please contribute if you find this software useful.
For info, please visit http://www.isc.org/dhcp-contrib.html
socket: Protocol not available - make sure CONFIG_PACKET and CONFIG_FILTER
are defined in your kernel configuration!
exiting.
Natomiast 'dhclient-2.0.x' "mówi":
No broadcast interfaces found - exiting.
Myślę, że 'dhclient' dobrze podpowiada, ale ja "nie umiem tego przeczytać".
Jakie moduły powinienem zaznaczyć, żeby to chodziło?
--
huan
Reply to: