Re: Upgrade Debian 6.0 => 7.0 klappt nicht.
Christian Schmidt schrieb:
12.09.2013 11:48, Ralf Lehmeier:
service networking start
* Configuring network interfaces...
ifup:
failed to open statefile /run/network/ifstate: No such file or directory
[fail]
Wie geht es jetzt weiter?
Wird Deine Netzwerkkarte korrekt erkannt? Der Output von "dmesg | grep
-i net" sowie "dmesg | grep -i eth" könnte hilfreich sein - ebenso wie
der von "lspci".
dmesg | grep -i net
[ 0.009973] Initializing cgroup subsys net_cls
[ 0.156757] NET: Registered protocol family 16
[ 0.204605] NET: Registered protocol family 2
[ 0.208658] NET: Registered protocol family 1
[ 0.548437] audit: initializing netlink socket (disabled)
[ 0.659909] NET: Registered protocol family 10
[ 0.660881] NET: Registered protocol family 17
[ 0.661378] Initalizing network drop monitor service
[ 0.942435] Intel(R) PRO/1000 Network Driver - version 7.3.21-k5-NAPI
[ 1.316981] e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network
Connection
[ 1.317022] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
[ 1.317102] r8169 0000:01:04.0: (unregistered net_device): no PCI
Express capability
[ 22.027324] <30>udevd[414]: renamed network interface eth1 to rename3
[ 22.060423] <30>udevd[415]: renamed network interface eth0 to eth1
[ 22.078478] <30>udevd[414]: renamed network interface rename3 to eth0
[ 31.369154] ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 31.392611] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[ 31.411637] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 32.222958] NET: Registered protocol family 31
[ 32.543267] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
dmesg | grep -i eth
[ 1.316981] e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network
Connection
[ 1.317022] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
[ 1.318262] r8169 0000:01:04.0: eth1: RTL8169sc/8110sc at
0xffffc9000103ac00, 00:1b:fc:df:47:d7, XID 18000000 IRQ 19
[ 22.027324] <30>udevd[414]: renamed network interface eth1 to rename3
[ 22.060423] <30>udevd[415]: renamed network interface eth0 to eth1
[ 22.078478] <30>udevd[414]: renamed network interface rename3 to eth0
[ 31.369154] ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 31.388025] e1000: eth1 NIC Link is Up 1000 Mbps Full Duplex, Flow
Control: RX/TX
[ 31.392611] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[ 32.543267] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 42.004054] eth1: no IPv6 routers present
lspci
00:00.0 Host bridge: Intel Corporation 82945G/GZ/P/PL Memory Controller
Hub (rev 02)
00:02.0 VGA compatible controller: Intel Corporation 82945G/GZ
Integrated Graphics Controller (rev 02)
00:1b.0 Audio device: Intel Corporation NM10/ICH7 Family High Definition
Audio Controller (rev 01)
00:1c.0 PCI bridge: Intel Corporation NM10/ICH7 Family PCI Express Port
1 (rev 01)
00:1d.0 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI
Controller #1 (rev 01)
00:1d.1 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI
Controller #2 (rev 01)
00:1d.2 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI
Controller #3 (rev 01)
00:1d.3 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI
Controller #4 (rev 01)
00:1d.7 USB controller: Intel Corporation NM10/ICH7 Family USB2 EHCI
Controller (rev 01)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1)
00:1f.0 ISA bridge: Intel Corporation 82801GB/GR (ICH7 Family) LPC
Interface Bridge (rev 01)
00:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE
Controller (rev 01)
00:1f.2 IDE interface: Intel Corporation NM10/ICH7 Family SATA
Controller [IDE mode] (rev 01)
00:1f.3 SMBus: Intel Corporation NM10/ICH7 Family SMBus Controller (rev 01)
01:04.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
RTL-8110SC/8169SC Gigabit Ethernet (rev 10)
01:09.0 Ethernet controller: Intel Corporation 82543GC Gigabit Ethernet
Controller (Copper) (rev 02)
01:0a.0 Ethernet controller: Atheros Communications Inc. AR5212/AR5213
Wireless Network Adapter (rev 01)
Hilft dir das weiter ?
MfG R.Lehmeier
Reply to: