System locale charset is ANSI_X3.4-1968
Moin!
Ich bekomme beim Start von k3b folgende Fehlermeldung:
System locale charset is ANSI_X3.4-1968
Your system's locale charset (i.e. the charset used to encode filenames) is
set to ANSI_X3.4-1968. It is highly unlikely that this has been done
intentionally. Most likely the locale is not set at all. An invalid setting
will result in problems when creating data projects.
Solution: To properly set the locale charset make sure the LC_* environment
variables are set. Normally the distribution setup tools take care of this.
Aber in meiner environment habe ich alles richtig gesetzt:
% cat /etc/environment
LANG="C"
LC_ALL="C"
LANGUAGE="C"
% echo $LANG $LC_ALL $LANGUAGE
C C C
Wo muss ich das meinem System noch beibiegen?
Gruß
Marc
--
Don't go around saying the world owes you a living. The world owes you
nothing. It was here first.
-- Mark Twain
Reply to: