Re: NIC-Probleme und zwar gehaeuft
Marcus Krause schrieb:
> Micha Beyer schrieb:
>> Hallo Liste,
>>
>> was ist denn hier im Moment los?
>
> Das Frage ich mich auch.
>
> Hier steht ein Server (Etch), der auch Probleme macht:
>
> lspci: Ethernet controller: Broadcom Corporation NetXtreme BCM5751
> Gigabit Ethernet PCI Express (rev 11)
>
> uname -r: 2.6.17-marcus-server (angepasster Kernel mit Debian Patches)
>
> udev (Version 0.100-1)
Kann damit vielleicht jemand was anfangen?
dmesg.0 = eth0 wurde nicht gefunden
dmesg = eth0 funktioniert
srv:/var/log# diff dmesg.0 dmesg
1,13c1
< _irq 9 global_irq 9 high level)
< ACPI: IRQ0 used by override.
< ACPI: IRQ2 used by override.
< ACPI: IRQ9 used by override.
< Enabling APIC mode: Flat. Using 1 I/O APICs
< Using ACPI (MADT) for SMP configuration information
< Allocating PCI resources starting at 50000000 (gap: 40000000:bec00000)
< Built 1 zonelists
< Kernel command line: root=/dev/sda9 ro
< mapped APIC to ffffd000 (fee00000)
< mapped IOAPIC to ffffc000 (fec00000)
< Enabling fast FPU save and restore... done.
< Enabling unmasked SIMD FPU exception support... done.
---
> U exception support... done.
16c4
> tg3.c:v3.59.1 (August 25, 2006)
> ACPI: PCI Interrupt 0000:07:00.0[A] -> GSI 18 (level, low) -> IRQ 18
> PCI: Setting latency timer of device 0000:07:00.0 to 64
> eth0: Tigon3 [partno(BCM95751) rev 4101 PHY(5750)] (PCI Express)
10/100/1000BaseT Ethernet 00:30:05:98:c2:f8
> eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] Split[0] WireSpeed[1]
TSOcap[1]
> eth0: dma_rwctrl[76180000] dma_mask[64-bit]
329a324,325
> tg3: eth0: Link is up at 1000 Mbps, full duplex.
> tg3: eth0: Flow control is on for TX and on for RX.
Teile der boot.0:
SIOCSIFADDR: No such device
eth0: ERROR while getting interface flags: No such device
SIOCSIFNETMASK: No such device
SIOCSIFBRDADDR: No such device
eth0: ERROR while getting interface flags: No such device
eth0: ERROR while getting interface flags: No such device
Gruß,...
...Marcus.
Reply to: