Kernel 2.6.9 und USB Brenner
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hallo,
seit ich den Kernel 2.6.9 (von kernel.org) installiert habe findet
Xcdroast den Brenner nicht mehr. Dieser wird wohl als /dev/uba
eingerichtet (udev ist installiert). Auch wenn ich Xcdroast direkt sage
das der Brenner unter /dev/uba zu finden ist, zeigt es Ihn nicht an.
Ein dmesg bringt beim Anschließen des Brenners das hier:
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 1 port detected
PCI: Enabling device 0000:07:00.2 (0000 -> 0002)
ACPI: PCI interrupt 0000:07:00.2[C] -> GSI 11 (level, low) -> IRQ 11
ehci_hcd 0000:07:00.2: NEC Corporation USB 2.0 (#2)
ehci_hcd 0000:07:00.2: irq 11, pci mem e1a96000
ehci_hcd 0000:07:00.2: new USB bus registered, assigned bus number 5
ehci_hcd 0000:07:00.2: USB 2.0 enabled, EHCI 0.95, driver 2004-May-10
hub 5-0:1.0: USB hub found
hub 5-0:1.0: 2 ports detected
usb 3-1: USB disconnect, address 2
usb 5-1: new high speed USB device using address 2
uba: resid 18 len 0 act 0
uba: device 2 capacity nsec 50 bsize 512
uba: tag orig 0x3 reply 0x2
uba: made changed
uba: tag orig 0x4 reply 0x3
uba: device 2 capacity nsec 50 bsize 512
uba: tag orig 0x5 reply 0x4
uba: device 2 capacity nsec 50 bsize 512
~ uba:end_request: I/O error, dev uba, sector 0
Buffer I/O error on device uba, logical block 0
end_request: I/O error, dev uba, sector 2
Buffer I/O error on device uba, logical block 1
end_request: I/O error, dev uba, sector 4
Buffer I/O error on device uba, logical block 2
end_request: I/O error, dev uba, sector 6
Buffer I/O error on device uba, logical block 3
end_request: I/O error, dev uba, sector 6
Buffer I/O error on device uba, logical block 3
end_request: I/O error, dev uba, sector 4
Buffer I/O error on device uba, logical block 2
end_request: I/O error, dev uba, sector 2
Buffer I/O error on device uba, logical block 1
end_request: I/O error, dev uba, sector 0
Buffer I/O error on device uba, logical block 0
~ unable to read partition table
~ uba:end_request: I/O error, dev uba, sector 2
Buffer I/O error on device uba, logical block 1
end_request: I/O error, dev uba, sector 4
Buffer I/O error on device uba, logical block 2
end_request: I/O error, dev uba, sector 6
Buffer I/O error on device uba, logical block 3
end_request: I/O error, dev uba, sector 0
Buffer I/O error on device uba, logical block 0
~ unable to read partition table
Weiß jemand Rat?
Grüße,
- --
~ .~. ----------------------------
~ /V\ | Kai Timmer |
~ // \\ | mailto: email@kait.de |
~ /( )\ | ICQ: 67765488 |
~ ^'~'^ ----------------------------
Realität ist da wo der Pizzamann herkommt...
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)
iD8DBQFBmkbgN+WB672wENARAnOKAKDNWz9pavHGsnTNa9K9qdb57faGCwCfSLS6
RHC4sjndU4JXg1HmmZ5gsDg=
=027A
-----END PGP SIGNATURE-----
Reply to: