Re: eth2 ne seconfigure pas
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
mess-mate wrote:
> A dmesg|grep eth give :
> eth1: VIA Rhine at 0x1e800, 00:80:c8:ec:92:b5, IRQ 10.
> eth1: MII PHY found at address 8, status 0x7809 advertising 05e1
> Link 0000.
> eth2: RealTek RTL8139 at 0xec00, 00:e0:29:3c:34:bd, IRQ 12
> eth2: Identified 8139 chip type 'RTL-8139A'
> ( remark: 3C59x driver )
> eth1: link up, 10Mbps, half-duplex, lpa 0x0000
> eth0: setting half-duplex.
> ADDRCONF(NETDEV_UP): eth0: link is not ready
> eth1: no IPv6 routers present
> eth1: link up, 10Mbps, half-duplex, lpa 0x0000
> eth1: no IPv6 routers present
C'est une part du message tire de la liste anglaise.
C'est peut etre bete, mais pourquoi un "dmesg | grep eth" ne permet-il
pas de voir ce genre de probleme ? C'est fait pour recuperer les
messages du noyau survenu pendant le boot, non ?
En tout cas je retiens la commande "ip link".
- --
Franck Joncourt
http://www.debian.org
http://smhteam.info/wiki/
GPG server : pgpkeys.mit.edu
Fingerprint : C10E D1D0 EF70 0A2A CACF 9A3C C490 534E 75C0 89FE
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
iD8DBQFF4zh/xJBTTnXAif4RAkIGAJ9C41RT7d0npAPJ/HCECUw0TTQxcACguj6f
4wRskkT0Sik0sByWxABB0VA=
=qzSF
-----END PGP SIGNATURE-----
___________________________________________________________
All new Yahoo! Mail "The new Interface is stunning in its simplicity and ease of use." - PC Magazine
http://uk.docs.yahoo.com/nowyoucan.html
Reply to: