Problème entre versions Ndiswrapper
Bonjour la liste,
J'ai un problème sur ma testing depuis un moment, dès que je met à jour
Ndiswrapper, impossible de me connecter.
Je me suis penché de nouveau hier soir sur le problème et voilà ce que j'ai
trouvé :
- Jusqu'à Ndiswrapper 1.15 pas de problèmes.
#modprobe ndiswrapper
ACPI: PCI interrupt for device 0000:02:00.0 disabled
ndiswrapper version 1.15 loaded (preempt=yes,smp=no)
ndiswrapper: driver mrv8335 (Marvell,02/22/2005,3.1.1.7) loaded
ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKA] -> GSI 9 (level, low) ->
IRQ 9
PCI: Setting latency timer of device 0000:02:00.0 to 64
ndiswrapper: using irq 9
wlan0: vendor: ''
wlan0: ndiswrapper ethernet device 02:11:22:33:70:ce using driver mrv8335,
11AB:1FAA.5.conf
wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP
with WPA, WPA2, WPA2PSK
wlan0: no IPv6 routers present
#/etc/init.d/networking start
/etc/network/options is deprecated.
Setting up IP spoofing protection...done (rp_filter).
Reconfiguring network interfaces...Failed to bring up eth0.
Trying to associate with 00:07:cb:57:db:68 (SSID='chezmoi' freq=2462 MHz)
Associated with 00:07:cb:57:db:68
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
Associated with 00:07:cb:57:db:68
WPA: Key negotiation completed with 00:07:cb:57:db:68 [PTK=TKIP GTK=TKIP]
CTRL-EVENT-CONNECTED - Connection to 00:07:cb:57:db:68 completed (auth) [id=0
id_str=]
CTRL-EVENT-TERMINATING - signal 2 received (wpa_supplicant n'est en démon pour
ces tests)
Et si je passe en Ndiswrapper 1.16 :
#modprobe ndiswrapper
ACPI: PCI interrupt for device 0000:02:00.0 disabled
ndiswrapper version 1.16 loaded (preempt=yes,smp=no)
ndiswrapper: driver mrv8335 (Marvell,02/22/2005,3.1.1.7) loaded
ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKA] -> GSI 9 (level, low) ->
IRQ 9
PCI: Setting latency timer of device 0000:02:00.0 to 64
ndiswrapper: using irq 9
wlan0: vendor: ''
wlan0: ndiswrapper ethernet device 02:11:22:33:70:ce using driver mrv8335,
11AB:1FAA.5.conf
wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP
with WPA, WPA2, WPA2PSK
wlan0: no IPv6 routers present
(Pour info les sorties sont identiques pour modprobe)
#/etc/init.d/networking start
/etc/network/options is deprecated.
Setting up IP spoofing protection...done (rp_filter).
Reconfiguring network interfaces...Failed to bring up eth0.
Bind socket to interface: No such device
Trying to associate with 00:07:cb:57:db:68 (SSID='chezmoi' freq=2462 MHz)
Association request to the driver failed
Authentication with 00:00:00:00:00:00 timed out.
Failed to initiate AP scan.
CTRL-EVENT-TERMINATING - signal 2 received
Failed to disable WPA in the driver.
J'ai ce "bind socket: no such device" qui apparait et aussi je crois un
"wlan0 link not ready"
Ma carte PCMCIA est à base de mrv8335, j'ai cherché un driver plus récent sans
succès.
Ndiswrapper est compilé depuis les sources sourceforge.
Ndis source 1.23 testing ne fonctionne bien sur pas mieux :(
Si vous aviez des infos ce serait sympa.
Merci d'avance
@+
Sil
Reply to: