install de lm-sensors
Bonjour,
J'ai installé le paquet lm-sensors sous debian sid avec apt.
Jai recompilé mon noyau pour le support des différents modules, sauf
pour smbus-arp, que je n'ai pas trouvé mais appremment, celui-là n'est
pas obligatoire non?
Voila ce qu'ils ont rajouté dans mon /etc/modules:
# Generated by sensors-detect on Fri Jan 27 15:14:21 2006
# I2C adapter drivers
i2c-i801
# I2C chip drivers
# Warning: the required module asb100 is not currently installed on your
system.
# For status of 2.6 kernel ports see
http://secure.netroedge.com/~lm78/supported.html
# If driver is built-in to the kernel, or unavailable, comment out the
following line.
asb100
# Warning: the required module smbus-arp is not currently installed on
your system.
# For status of 2.6 kernel ports see
http://secure.netroedge.com/~lm78/supported.html
# If driver is built-in to the kernel, or unavailable, comment out the
following line.
#smbus-arp
Donc, j'ai décoché smbus-arp.
Quand je tape sensors, voila ce qu'il m'affiche:
sb100-i2c-0-2d
Adapter: SMBus I801 adapter at e800
VCore 1: +1.71 V (min = +1.66 V, max = +1.84 V)
+3.3V: +3.34 V (min = +3.14 V, max = +3.47 V)
+5V: +5.05 V (min = +4.76 V, max = +5.24 V)
+12V: +11.43 V (min = +10.82 V, max = +13.19 V)
-12V (reserved):
-11.94 V (min = -0.00 V, max = -0.00 V)
-5V (reserved):
-5.01 V (min = -0.00 V, max = -0.00 V)
CPU Fan: 3629 RPM (min = 1997 RPM, div = 4)
Chassis Fan:
0 RPM (min = 3994 RPM, div = 2)
Power Fan: 0 RPM (min = 3994 RPM, div = 2)
M/B Temp: +42°C (high = +45°C, hyst = +40°C)
CPU Temp (Intel):
+40°C (high = +60°C, hyst = +50°C)
Power Temp:
+124°C (high = +45°C, hyst = +40°C)
CPU Temp (AMD):
-41°C (high = +60°C, hyst = +50°C)
vid: +1.750 V (VRM Version 9.0)
alarms:
Ca a l'air correcte?
Sinon, un autre truc, l'ordi emet des sons une fois par minute à peu
près, depuis le chargement de ces modules.
Y'a moyen de stopper cela?
Merci
A+
Reply to: