Re: Compiling/Installing D-link Ethernet Card Module

[mike polniak <mikpolniak@adelphia.net>]

Arlo White wrote:
> I'm trying to install a D-Link DFE-530TX+ Module for my ethernet card.  I 
> found the via3043.c source code at there website and copyed it to my 
> /usr/src/via directory.

	This card uses the rtl8139 or 8139.too driver. I use both and
each works fine. Run> modprobe -l -t net to see if you already have the
module installed. If not, you may want to compile a new kernel and set
CONFIG_RTL8139.

-- 
LINUX~~nobody owns it~~everybody can use it~~anybody can improve it
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~