Re: Ethernet config
Hi,
Can you ping from the other machines to your linux machine ?
I see you use the 10base T port, does your hub indicate that the
netword card is functioning ?
You could also try changing to another 3com509 module. There are
differences betheen the PNP and non-PNP version of this card.
Kind regards,
Bart van Dommelen
email:dommel@horizon.nl
On 15 Jan 2001, at 20:58, Lorint Hendschel wrote:
> Hi,
>
> I am a 1st time Debian user. I installed slink on a machine successfully but I
> have problems setting up my home network. I have a 3com ISA 3C509 card. When
> I try to ping a machine on my network, ping just sits there with no output
> (except when I ping the Debian machine itself). When I stop it, I am told that
> all packets were lost.
>
> lsmod shows that the 3c509 module is loaded.
>
> Output of 3c5x9 -f:
> 3c5x9 found at 0x300
> Model number 3c509 version 8, base I/O 0x300, IRQ 10, 10baseT port.
> Primary physical address is 00:60:08:4d:c2:9a
> Alternate physical address is 00:60:08:4d:c2:9a
>
> Output of ifconfig:
> ethO Link encap:Ethernet HWaddr 00:60:08:4D:C2:9A
> inet addr:192.168.0.3 Bcast:192.168.0.255 Mask:255.255.255.0
> UP BORADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:1 errors:0 dropped:0 overruns:0 frame:0
> TX packets:364 errors:0 dropped:0 overrruns:0 carrier:0
> Collisions:0
> Interrupt:10 Base address:0x300
>
> Output of route:
> localnet * 255.255.255.0 U 0 0 4 eth0
> 127.0.0.0 * 255.0.0.0 U 0 0 8 lo
>
> cat /etc/hosts:
> 127.0.0.1 localhost
> 192.168.0.1 bele_plaece.cottages bele_plaece # this is a mdk7.2 machine
> 192.168.0.2 tchambe.cottages tchambe # this is a Win95 machine
> 192.168.0.3 sierveu.cottage sierveu # this is the debian machine
>
> Thanks for any help!
>
> --
> Lorint HENDSCHEL
>
>
> --
> To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
>
>
Reply to: