Bug#211128: Installer doesn't autoload eepro100

[Jerry Quinn <jlquinn@optonline.net>]

Package: installation-reports

INSTALL REPORT

Debian-installer-version: 09-15-2003 http://gluck.debian.org/cdimage/testing/netinst/i386/sarge-i386-netinst.iso
uname -a: 2.4.20-1-386
Date: 9-15-03 10:30
Method: How did you install?  What did you boot off?  If network
      install, from where?  Proxied?

Booting from CD.  I used the "linux" method.


Machine: Thinkpad T30
Processor: 1.8GHz Pentium4
Memory: 768MB
Root Device: IDE
Root Size/partition table:  Feel free to paste the full partition
      table, with notes on which partitions are mounted where.
Output of lspci:

Base System Installation Checklist:

Initial boot worked:    [O]
Configure network HW:   [E]
Config network:         [ ]
Detect CD:              [ ]
Load installer modules: [ ]
Detect hard drives:     [ ]
Partition hard drives:  [ ]
Create file systems:    [ ]
Mount partitions:       [ ]
Install base system:    [ ]
Install boot loader:    [ ]
Reboot:                 [ ]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Comments/Problems:

This is a partial report.  I haven't finished the install yet.

When I try to autodetect the ethernet, it identifies as eepro100,
which is correct.  However, the eepro100 wasn't found.  It also
correctly detected the built-in wireless as orinoco_pci, also not
found.

I had to select e100 by hand to bring up the ethernet during the
install.  Please consider adding more driver modules :-)